Publicité
Preliminary setup with Windows XP
(Service Pack 2; other operating systems may vary slightly)
1. Plug the free end of the USB cable into the USB port on your computer. The
microphone's blue LED will illuminate, indicating the mic is receiving power. Your
computer will automatically recognize the USB device and install a driver.
2. In the lower right portion of your screen you may see a message that new hardware
was found; or you may see a driver software installation notice.
3. To select the AT2020 USB as your default recording device, begin at your
Select
Control
Panel.
6
4. Select
Sounds and Audio
5.
.Select the
the default recording device. (You should see a green check mark beside the
AT2020 USB.).
Start
menu.
Devices.
Recording
tab. Make sure that the
AT2020 USB
EN
microphone is set as
7
Publicité
