KRONAsteel PAOLA Série Guide De L'utilisateur page 10

EN Application sheet
lation, connection and repair.
The model name and important technical charac-
teristics of the kitchen hood are specified inside
the case.
Security measures
The kitchen hood is connected to the power net-
work with the voltage of 220/240 V – 50 Hz, using
a wall outlet with earthing only. The kitchen hood
has 1 electrocution protection class.
Use the light bulbs with the voltage no higher
than specified in the Instructions.
It is forbidden to operate the kitchen hood with-
out an aluminum grease filter.
The air from the kitchen hood should be removed
to the air shaft only (its removal to the chimney is
strictly forbidden).
SAFETY OF CHILDREN
Children often do not understand the danger of
electrical appliances. While the kitchen hood is
functioning, watch your children and do not al-
low them to work with it. Packaging materials
(such as polyethylene film) may cause suffoca-
tion. Keep them out of reach of children
DESCRIPTION OF THE HOOD
The outer part of the hood consists of the following
components (see Figure 1):
1. Hood control panel.
2. The hood housing.
3. Aluminum grease-collecting filter.
4. Light bulbs.
5. Decorative hood duct.
An additional accessory for extracting is a carbon
filter (not included in the kit, Fig. 2).
The carbon scavenging filter is used for air filtration
in the room when the hood is operating in the recir-
culation mode (see Operation of the hood"). Coal
filter can be purchased from a retailer.
8
KITCHEN HOODS
Your hood has 3 ventilation speeds. Depending on
how large the evaporation is during cooking and
frying, you can choose the most suitable ventilation
speed. For more complete air purification, turn on
the stove and the hood at the same time.This will
make the ventilation process more efficient. When
you have finished cooking, leave the hood to work
for some time, this will allow you to get rid of steam
and undesirable odors in the kitchen fully.
On the front panel of the hood there is a switch but-
ton for the operating modes of the motor and the
light bulbs (see Fig.3), its elements have the follo-
wing functions:
1. Power button.
2. Switch on the first ventilation speed.
3. Switch on the second ventilation speed.
4. Switch on the third ventilation speed.
5. Turn on / off the light bulbs.
When the hood is connected to the mains, the logo
and the hood enable button light are on the front
panel of the hood (Figure 3, item 1). To activate the
hood, you must act on the on/off button for at least
2 seconds. After that, the other buttons on the cont-
rol panel light up on the front panel. With their help,
you can choose one of the speed of work of the
hood or turn on / off the backlight.
To turn off the hood, press button 1 again. At the
same time, the backlight bulbs go out and any of
the selected hood operating speeds is turned off.
The hood turns into standby mode.
Attention!
In the standby mode (the hood motor and the
backlight are off), the logo on the front panel fli-
ckers slowly – it cyclically lights up and dims. When
you turn on any speed of the motor or backlight,
the logo goes into a different mode of operation – it
glows constantly without flickering.
These functions of the logo are incorporated in the
design of the hood specially, they can not be swit-
ched off with the control panel of the hood.
HOOD CONTROL
Control panel