Hans SANITAS SBM 20 Mode D'emploi page 12

• When the pressure in the cuff is slowly released and the pulse is recorded, the sym-
bol appears.
• Once measurement has ended, residual air pressure is released very quickly and the
symbol appears. pulse, systolic and diastolic pressures are displayed.
• Now press memory keys M1 or M2 to select the required user memory. If you do not
select any user memory, the measurement result is assigned for storage in the user me-
mory which was last used. The symbol 'M1' or 'M2' appears accord ingly in the display.
• You can interrupt measurement at any time by pressing the ON/OFF button.
• Switch off the blood pressure monitor with the ON/OFF button. The measurement
result is then saved to the selected user memory. If you forget to switch off the
device, it switches off automatically after approx. 3 minutes. Even then, the result is
still saved to the selected user memory.
Wait at least 5 minutes before any new measurement!
9. Memory recall
You can recall stored results from the two user memories and display averages.
• Press memory buttons M1 or M2. First the average is displayed of all the results held
in this user memory. This is indicated by reading 'A'.
• Continue pressing the memory button to recall other individual measurement re-
sults - the first result to appear is that of the most recent value measured. These
individual values are indicated by memory location numbers 1 to 30. After approx.
4 seconds, the date of the respective measurement result is displayed and then the
time after a further 4 seconds.
• Once 30 individual values are in the memory, the oldest value is deleted in o rder to
make room for the new measured value.
• Switch off the device using the ON/OFF button or else the device will switch off au-
tomatically after approx. 30 seconds.
Note:
You can also use the two user memories to save measurement results
separately, e.g. in the morning and evening.
Deleting saved values
You can delete saved values individually or else you can delete all of them.
• To delete individual values, first select the stored value you wish to delete and keep
memory button M1 or M2 depressed. The display starts blinking. Keep holding the
button depressed until the display has completely cleared.
• To delete an entire user memory, you have to select the appropriate user memory.
The average is displayed and indicated with 'A'. Hold the memory button M1 or M2
depressed until the display starts blinking and keep the button depressed until the
display completely clears.
10. cleaning
• Clean your blood pressure computer carefully only with a slightly moistened cloth.
• Do not use detergents or solvents.
• On no account must you immerse the computer in water, otherwise liquid can enter
it and cause demage.
• When storing the device, make sure that no heavy objects are placed on top of it.
Remove the batteries. The cuff tube should not have any sharp kinks
11. error recovery
Error messages may appear if
• you move or talk during measurement (ERR 1)
• the cuff tube is not inserted properly (ERR 2)
12