Cleaning The Drain Pump Filter - KENMORE ELITE 796.4168 Serie Mode D'emploi Et Guide D'utilisation

CARE AND CLEANING
MAINTENANCE (continued)

Cleaning the Drain Pump Filter

Your Washer is equipped with a filter that helps prevent
excess lint and foreign objects like buttons, keys, and
coins from causing damage to the pump. If the washer
fails to drain properly, unplug the washer and allow the
water to cool, if necessary, before proceeding.
Open the drain pump filter access panel.
1
Drain Hose
Unclip the drain hose and pull it out. Place the end
2
of the drain hose into a shallow pan or a floor drain.
Make sure not to pull the hose out too far, or it may
not drain properly.
Plug
Remove the plug from the drain hose, and allow the
3
water to drain completely.
NOTE: If there is a large amount of water in the drum,
you may have to empty your container several times.
Twist the pump filter counterclockwise to remove.
4
Remove any lint and foreign objects from the pump
filter. Insert pump filter back into opening and twist
clockwise to secure. Be sure to close the drain pump
filter access panel.
26
Pump Filter