Publicité
Les langues disponibles
Les langues disponibles
1. Disconnect the main plug from the AC socket in order to avoid the risk of
serious injuries and wait at least 15 minutes until the overload guard has reset.
Now tear off excess paper from the top of the shredder or remove it.
2. Reconnect the main plug to the AC socket and set the switch to the REV position.
Pull the remaining paper away from the shredding blades. Afterwards, set the
switch back to the AUTO position. If necessary, repeat this step.
3. With the switch in the AUTO position and the open feed slot, you may now continue
the normal shredding process.
Technical data:
Shredding type:
Size of cut:
Shredding capacity:
Feed width:
Feed width for CDs/DVDs:
Input voltage:
Dimensions:
Waste basket:
Operating cycle:
Delivery:
250 CD Shredder
Manual
Cleaning:
Danger! Unplug the power cord before cleaning. There is a risk of electric shock!
Warning! The blades of the device are very sharp! Danger of injury!
1. Empty the drip trays regularly.
2. Clean the drip trays and paper cutter with a slightly dampened cloth and possibly
with a mild detergent.
3. Remove any residue in the cutting holes with a suitable object. Make sure that
while the plug is pulled in order to avoid injuries.
HANDLING THE GUARANTEE
Thank you very much for purchasing this GENIE product. Please note the following
advice whenever this machine does not function faultlessly, contrary to expectations.
Strip-cut
7 mm (paper), 4 pieces (CD/DVD or credit card)
7 pages DIN A4 (80g), 1 CD/DVD or credit card
220 mm
120 mm
220-240 volt alternating current, 50 Hz, 0.7 A
300 x 185 x 320
ca. 13 l capacity
2 min. ON, 60 min. OFF
- 12 -
Publicité
