Electrical Connection - Candy TRIO 503/1 Notice D'emploi Et D'installation

INSTALLATION - ELECTRICAL CONNECTION
"The installation must conform to the standard directives".
CANDY declines all responsibility for any damage that may be caused by unsuitable or
unreasonable use.
Warning :
• Always check before any electrical operation, the supply tension shown on the electricity
meter, the adjustment of the circuit-breaker, the continuity of the connection to earth to
the installation and that the fuse is suitable.
• The electrical connection to the installation should be made via a socket with a plug
with earth, or via an omni pole cut-out switch with an opening gap of at least 3 mm.
If the appliance has a socket outlet, it must be installed so that the socket outlet is
accessible.
CANDY cannot be held responsible for any accidents resulting from the use of an
appliance that is not connected to earth, or with a faulty earth connection continuity.
• Any queries regarding the power supply cord should be referred to After Sales
Service or a qualified technician.
Warning! This appliance must be earthed. In the absence of adequate earthing you
will notice that when touching the metal parts of your appliance an electrical
dispersion can be felt due to the presence of a radio interference suppressor.
A power cord is not supplied with this Trio, but it is equipped with a terminal block
that enables you to choose the correct connection for the particular power supply.
The terminal block is located at the back of the Trio.
To open the terminal block :
. Locate the two tabs on the sides,
. place the screwdriver blade on the front of the tab, insert it
. Lift the cover off.
Terminal block
and press down
x 3 bars shunts
,
31