Unitekno C200A Manuel D'utilisation page 19

HOW TO FILL WITH WATER
The appliance is equipped with an
automatic filling system, and may be
filled with water while the heater is
under pressure.
IMPORTANT!
When the device is used for the first
time, it is necessary to proceed as
follows:
unscrew the brass screw with a
hexagon socket screw key; pour one
liter of water into the boiler; close it
again; pour water into the cold water
reservoir (maximum 2,5 liters); turn
on.
The same procedure must be followed
each time the boiler is decalcified (see
chapter on maintenance).
ATTENTION!
Do not use distilled or demineralized
water. It could cause the unit to
malfunction.
18
HOW TO WORKTHEHEATER
Insert the plug into the mains socket.
Press the start button .
The warning light switches on.
This shows that the appliance is
working.
Press the button to use the iron
(only 902-903). The iron can be used
without the steam heater, for no-steam
ironing.
The warning light switches on to
indicate that the iron is operating in
the economy mode.
Wait a few minutes until the warning
light switches off. Steam is now
available for cleaning or ironing.
NB: while the appliance is in use, the
warning light will switch on and
off several times; this warning light
may be ignored while the appliance
is being used.
An electronic bell will ring to warn
that there is no water in the heater.
The warning light indicates that
the cold water reservoir is empty.
The appliance has an economy mode
which is activated automati-cally when
steam is not used for a few minutes.
The ironing is normally done in the
economy mode.
M = Pressure gauge
This indicates the pressure inside the
steam generator
S = Steam control
Each time the appliance is used, a few
drops of water may come out when
the start button is pressed for the first
time.
This is quite normal and is due to
condensate which forms when the
tube is still cold.
The same thing may happen after an
interval of any great length.