Unitekno C200A Manuel D'utilisation page 17

USE
HOW TO CONNECT THE
ACCESSORIES
Make sure that the appliance is
disconnected from the mains socket.
Attach the connector (C) to the heater
as follows:
Hook the socket flap on to the lower
hook of the connector.
Pull the flap well open.
Insert the connector into the socket
until it clicks into place.
16
Press the button to unlock and extract
the connector.
CABLE REWIND
Turn the steam generator as shown in
the diagram in order to rewind the
cable inside the coiler. Fasten the
cable terminal with the special lock.
HANDLE
This is attached to the heater by means
of the connector (C) and enables all
the cleaning accessories to be
attached.
The handle has a push-button(S) to
deliver the steam.
The push-button for delivering steam
is a low voltage (12V) switch.
EXTENSIONS
These are connected to the handle so
that the work field is widened. The
extensions have the same attachment.
HOW TO FASTEN THE PIECES
TOGHETER
All the pieces have a bayonnet joint.
Make sure that the following
operations are carried out before
switching on the steam.
1) Turn the ring in the direction shown
in the drawing.
2) Insert the piece.
3) Turn the ring in the opposite
direction to lock into position
(CLOSED position).