Network Settings - Comelit IPPTZ120IR Manuel D'utilisation

Drawing: Click Drawing, then set the video tampering area.
Clear: Click Clear to clear the current video tampering areas.
Sensitivity: The higher of the sensitivity, the obvious of the video tampering effect.
Email: Send Email to appointed mailbox when alarm triggered.
Snap: Snapshot and install the picture in the HDD when alarm triggered.
Record: Video record and installed in the HDD or send as FTP to keep when alarm triggered.
Alarm Output: There is a warner connect the alarm output port, alarm triggered the embedded relay switch to make alarm output.
Enable PTZ: Alarm input to link the PTZ motion.
Preset: Alarm input to link the preset.
Snap Interval: Set the snapshot interval time
Snap Count: Set the snapshot count in every second
After all parameters setting completed, click "Save" and the it comes into effect immediately.

Network Settings

Network High Speed Dome "Network Settings" interface as figure 3-18.
IPV4: IP protocol version 4
IPV6: IP protocol version 6
Static IP: The device IP address is permanent
DHCP: Click DHCP, when turn on the router's DHCP, the camera will get the IP address from router automatically
IP address: Input the corresponding numbers to change the IP address
Subnet Mask: Input the corresponding IP subnet mask
Default Gateway: Input the corresponding gateway address
DNS 1: DNS server IP address
DNS2: DNS server standby IP address
SNMP: To detect whether it will cause any management attention as device connected on the network
SNMP Manager IP:
HTTP Port: Input the corresponding port ( Default is 80)
HTTPS Port: Input the corresponding port ( Default is 4433)
Enable PPPOE: When click Enable PPPOE, the device and HTTP port will mapping to the router automatically
Multicast Add: Input the corresponding multicast address
Multicast Port：Input the corresponding multicast port (Default is 28080)
Device Port: Input the corresponding device port (Default is 5050)
Enable PPPOE: Click to enable PPPOE server
PPPOE server: Input the PPPOE server number
Username:
Password: Input the password
Confirm pwd: Input the password again to confirm it
After all parameters setting completed, click "Save" and the it comes into effect immediately.
Input the corresponding SNMP manager IP address
Input the username
Figure 3-18
15