Connecting Speakers - Esoteric Grandioso M1X Mode D'emploi

Connecting speakers

Notes about speaker cables
o Use commercially-available speaker cables to connect the speakers.
o Use the shortest speaker cables possible. The longer the cable, the
greater the resistance value and the more that damping perfor-
mance is reduced. Moreover, length also increases inductance and
capacitance, degrading the sound quality of high frequencies.
o Use left and right speaker cables that have the same length.
How to connect speaker cables
Use commercially-available speaker cables to connect the + terminal
of the unit to the + terminal of the speaker and the − terminal of the
unit to the − terminal of the speaker.
o Use speakers with at least 4Ω impedance.
o If the exposed tip of the core wire of a speaker cable contacts
another cord or terminal, a short could occur.
Never allow a speaker cable to short.
o Do not connect more than one amplifier to a speaker.
o Do not bundle speaker cables with power cords. Doing so could
cause noise.
V
The power plug should always be disconnected
when connecting speaker cables.
Locknut B
When using banana plugs
Loosen locknut A and insert the plug into the opening in the end of
the terminal. Then, tighten locknut A.
o Keep locknut B tightened when using.
o Carefully read the instructions for the banana plugs that you are
using.
Notice about the European model
In accordance with European safety regulations, connecting
banana plugs to speaker terminals is not allowed on European
models.
The holes into which banana plugs could be inserted have been
covered with black caps. Connect speakers using bare wires or
spade connectors.
If a black cap should become separated from its terminal, return
it to its original position.
12
Locknut A
When using bare wires
Loosen locknut B and insert the core wire in the hole. Then, tighten
locknut B.
o The hole for the insertion of the core wire is open vertically.
Cross-sections
o The maximum wire diameter that can be inserted is 4 mm (5/32").
When using spade connectors
Loosen locknut B and insert the spade connector. Then, tighten lock-
nut B.
o Use a spade connector with an inside diameter of at least 8 mm
(5/16").
Terminal cross
section
8 mm (5/16")
or more