Publicité
Les langues disponibles
Les langues disponibles
11. PHANTOM SWITCH
This switch is recessed to prevent accidental operation and has a corresponding red LED indicator; it should
NOT be operated while the mixer is live.
NOTE:
•
It should be pre-selected during setting up with the main output faders and MIC input gain controls
down.
•
ALL XLR MIC inputs will be phantom powered when selected. Some microphones that do NOT
require phantom supply may not operate or are damaged – check instructions.
•
The Jack Line inputs will be unaffected and can be used as normal.
(Your service station may be able to disable the Phantom Power)
12. 2 TRACK TAPE OUTPUT – Left and Right RCA Socket Outputs (unbalanced)
Nominal '0' Output Level:
Output impedance:
Load impedance (min):
The signal is derived from the main stereo output mix after the output faders.
13. 2 TRACK TAPE INPUT – Left and Right RCA Socket Inputs (unbalanced)
Normal Input Sensitivity:
Input impedance:
Signal is routed to the main stereo output before the faders and the monitoring system.
14. PLAYBACK SWITCH
Allows ON/OFF control of Playback input signal onto the main stereo output mix.
15. PLAYBACK LEVEL CONTROL
Level control of the 2-track tape playback onto the main stereo output of the mixer (before the main output
faders) set for desired mix.
16. TAPE MONITOR SWITCH
This switch sets the Headphone and Led Meter Monitoring system over to Tape Playback monitoring (Before
the playback switch and level control).
17. PFL SWITCH
This switch sets the Headphone and Led Meters system over to PFL (input pre-fade listen) monitoring. It works
in conjunction with PFL switches on each input channel.
18. HEADPHONE LEVEL CONTROL
This control is used in conjunction with the switch to monitor signals within the mixer. With both Tape Monitor
and PFL switches 'OFF' the headphone system and Led meters will monitor the main stereo output.
19. HEADPHONE OUTPUT – 1/4" Stereo Jack Socket Output
Output wiring:
Tip = left signal
Ring = right signal
Sleeve = ground
Minimum Load impedance: 40 Ohm
MM10
-10dBv(316mV RMS)
600 Ohm
5K Ohm
316mV RMS (-10dBv)
5K Ohm
8
Publicité
