JBSYSTEMS MM-10 Mode D'emploi page 3

8. AUX SEND 1
This auxiliary send control is 'Post-fade' and can be used to control the mix of inputs being processed by
effects, etc. Its level will change with the channel fader (12).
9. AUX SEND 2
This auxiliary send control is 'Pre-fade' and can be used to control the mix of inputs to an independent output
such as monitoring. Its level will not change with channel fader (12).
Note: the Post-Fade option can only be selected by your service engineer.
10. PAN CONTROL
This control is used to set the stereo balance of the input signal and can 'Pan' it fully to the left or right.
11. PFL SWITCH
This switch and indicator allows pre-fade listen of input signals through the headphone and Led meters (useful
while setting gains or trouble shooting).
12. 60mm FADER
This slide control provides level control of input signal to the main stereo mix output and will also control the
Post-Fade Aux Send 1.
MM10 3