Publicité
Les langues disponibles
Les langues disponibles
Operation
Powersave (Camera heating off)
Switch the monitor on by pressing button 8
Remarks: Monitor keep the last setting in
memory (switched on, stand-by or powersave)
There are 3 ways to start up:
1. Monitor has been in powersave mode and will
be activated for 2 seconds (screen check) before
switching to powersave mode.
2. Monitor has been on and will after start up be
on.
3. Monitor has been in stand-by mode and will be
activated for 2 seconds (screen check) switching
to stand-by mode.In both modes (powersave or
stand-by), the LCD will be automaticly activated
when the camera selection wire is supplied.
Colour adjustment
Press buttons 4
and adjust the colour with buttons 6
Brightness adjustment
Press button 5
buttons 6
or 7
Contrast adjustment
Press button 4
buttons 6
or 7
Camera selection
Press button 1
camera in order; the LED of the selected camera
will light up. Hold button 1
seconds to activate the control circuits of the
cameras again and the indicator LED for button 1
goes out.
Remark: If manually another camera is selected,
the control circuits are deactivated. A control cir-
cuit activates an individual camera, for example,
when using the indicators or changing to reverse
gear.
Automatic brightness on/off
Press button 2
ness on and off.
Remark: By activating the automatic brightness
the monitor adjusts the brightness of the LCD
display according to the environment.
UM0206600 V2.2
and 5
at the same time
or 7
and adjust the brightness with
.
and adjust the contrast with
.
to show the picture from each
pressed in for 2
to switch the automatic bright-
Usermanual
Stand-by on/off
Press button 3
on and off.
Remark: If stand-by is switched on, the monitor
.
starts to work if one of the control circuits is
activated.
Disable/enable powerkey
Hold buttons 4
seconds to disable powerkey and 120 seconds to
enable it.
Objec t s in
C3
monitor are
C2
closer than
they
appear
C1
Buttons
1
Button no 1 = Camera selection
Button no 2 = Automatic brightness on/off
Button no 3 = Standby function on/off
Button no 4 = Contrast
.
Button no 5 = Brightness
Button no 6 = Adjustment -
Button no 7 = Adjustment +
Button no 8 = On/power save
to switch the stand-by function
and 5
pressed for 60
2
3
4
5
6
7
8
3
Publicité
