Cal One-Toutch Quick Procedure; Aligning Procedure Count; Handling Cameras; User File Backup - Corghi EXACT LINEAR Manuel D'utilisation

ing wheel clamp.
Check and adjust the toe curve,
only when the car no longer travels straight after
hitting a bump or a manhole cover, when pieces
of the suspension system have been replaced,
after an accident or when specifically required
by the manufacturer.
The toe curve checking and adjustment sequence
depends on the type of suspension installed
on the car: there are differences for cars with
STANDARD, SPORTS or ALL-TERRAIN chassis.
Follow the instructions on the screen for the
operations to be performed and the adapters
to be fitted on the checking tool.
CAL ONE-TOUCH QUICK
PROCEDURE
From the LOGO page, select the icons
and in succession to start the Cal One-
Touch quick procedure.
ALIGNING PROCEDURE
COUNT
The equipment now features a count of the
number of alignment jobs performed. The count
increases after performance of the ROC proce-
dure, including ROC skip.
To display the count, select the
and icons from the initial screen.

HANDLING CAMERAS

For all models in which it is expected to push
the movement of cameras and PAGE UP PAGE
DOWN keys to move the beam so as to vary the
height or angle of the beam.
- PAGE DOWN: abbassa il beam / ruota in basso
il beam.
66

USER FILE BACKUP

icon,
From the logo page, select the icons
and
The page shown in Fig. 32 will open, allowing
you to select the backup or restore procedure
of the data regarding:
• The databank.
• Files of jobs carried out.
• Customer databank.
• Calibration log.
Backup procedure:
In the window shown in Fig. 32, select the icon
DATA SAVING. The page shown in Fig. 33 will
open, and here it is possible to set:
• The path for saving (HARD DISK, REMOVABLE
SUPPORTS, etc.).
• The frequency of the autosaves.
• Confirmation of the user before carrying out
the autosaves.
• Saving in compressed format.
Press Continue in order to proceed. The save
will be indicated as in Fig. 34.
The programme returns to the page shown in
Fig. 32. Click on the icon
the LOGO page.
Restore procedure:
In the window shown in Fig. 32, select the DATA
RESTORE icon. The page shown in Fig. 36 will
open, and here it is possible to select the path
leading to the data to be restored.
,
Once the correct path has been selected,
the data regarding the save are shown in the
lines below.
Press Continue in order to proceed. The indica-
tion of Fig. 37 will appear.
Press Continue to proceed with the restore, or
Cancel to cancel the operation.
Once the restore is completed, the indication
of Fig. 38 will appear, informing you to restart
the alignment programme in order to register
the data restore.
The programme returns to the page shown in
Fig. 32. Click on the icon
the LOGO page.
, Fig. 31.
Operator's manual EXACT LINEAR
to go back to
to go back to