König SAS-IPCAM100B Mode D'emploi page 6

Enter WPS mode
2
Power on your IP camera. The status LED on the IP camera will be
green for about 15 seconds.
Programme Loading
3
The status LED will flash red for about 15 seconds.
Press the WPS button on your IP camera
4
Wait until the status LED flashes between red and green, then press
and hold the WPS/RESET button on your IP camera for about 2 seconds
to enter WPS mode. The status LED will be flashing green.
Enter WPS mode on the Wi‑Fi router
5
Press the WPS button on the Wi-Fi router
Selecting the Wi‑Fi router
6
Select the Wi-Fi router of your choice in the screen (see Figure 9).
Then select the tab
Figure 8
IP camera connects with Wi‑Fi router
7
Wait about 1-2 minutes. If the IP camera is successfully connected to
the Wi-Fi router, the status LED will become orange.
Otherwise the status LED will become a flashing red light. If the setup
is not successful, please go back to Step 1 and try again.
If successful, select the tab:
8
(see Figure 11), and follow the instructions.
Please enter a camera name and password for security and
to enter next step (see Figure 10).
Figure 9 Figure 10
6
ENGLISH