König SAS-IPCAM100B Mode D'emploi page 5

APPLE
Set the IP camera to connect to the Wi‑Fi router
Open up "Settings" on your iOS device and select "Wi-Fi" and let it
8
search for a network. The network will be "Wi-Fi-cam-p2p". Select
"Wi-Fi-cam-p2p" to connect.
Now, open the "uCare Cam" app and select the tab at the bottom of
9
the screen that says "Wi-Fi Connect".
Select "Router mode", then "Next". Enter here the Wi-Fi network name
10
(SSID) and password of your home router.
After the IP camera receives this information, it will restart. Please wait
11
for it to start up and connect to your Wi-Fi router. When it successfully
connects, the status LED colour will turn orange. It may take up to
5 minutes.
Then select the camera name in the "uCare Cam" app to connect.
12
Note: If the status LED colour does not turn orange, please check your
Wi-Fi router and make sure the IP camera is within the signal area of
your Wi-Fi router. Then try this setup again.
Install your IP camera by WPS connection mode
If your Wi-Fi router has a WPS (Wi-Fi Protected Setup) button, you can use it to
set up the IP camera. (Must enable WPA/WPA2 encryption in Router). On the
Wi-Fi router, you will see a button labelled "WPS". It may also be called "QSS" or
"AOSS"
Setup Wi‑Fi ‑ WPS mode
1
Open the "uCare Cam" app
and select "Wi-Fi Setting" or "Wi-Fi Connect" at the bottom of the
screen.
Select the tab:
then select the tab:
to enter Step 2 (see Figure 8).
5
ENGLISH