Install The Blades; Install The Wall Control - Fanelite 52YFT-1021 CANOUAN Mode D'emploi

Unscrew
halfway

11. INSTALL THE BLADES

Assemble the blades with their supports using the screws and washers provided. Caution, tighten the screws
carefully to avoid damaging the blades.
Position each blade / blade support assembly on the motor (the screws and washers can already be
pre-mounted on the motor) and tighten the screws. Make sure it is properly tightened to avoid excessive
vibration problems during start-up.

12. INSTALL THE WALL CONTROL

WARNING : Before proceeding to the electrical connections, carefully read the safety instructions in
this manual. Before any electrical connections, switch off all power and restart only when the instal-
lation is completed. Electrical connections must be made in accordance with current regulations and
by a qualified electrician.
The ceiling fan is usually installed in place of a bulb and the wall control in place of the bulb switch. Remove
the wall plate and existing switch.
Take your wall control out of its packaging. The wall control is installed by default by recessed it into the wall.
You can also use a suitable surface mount housing.
Remove the knob and the plate.
Then correctly position the switch having previously made the 2 electrical connections below and fix it using
the screws provided.
18
Unscrew
completely