Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Chapter 6. Ordinary maintenance
6.7. Pneumatic diagram
L
Air supply
"A" plier opening / closing cylinder
L1
L2
"B" plier opening / closing cylinder
"A" plier carriage return cylinder
L3
L4
"B" plier carriage return cylinder
L5
Central welding device lifting cylinder
"A" plier opening / closing solenoid valve
L6
L7
"B" plier opening / closing solenoid valve
"A" plier carriage return solenoid valve
L8
L9
"B" plier carriage return solenoid valve
L10
Central welding device lifting solenoid valve
Pliers pressure reducer
L11
L12
Pressure reducer
Manometer
L13
6.8. Disassembling, demolition and elimination of residuals
ATTENTION!
All disassembling and demolition operations must be done by qualified personnel with mechanical and
electrical expertise required to work in safe conditions.
Proceed as follows:
1.
disconnect machine from power mains
2.
disassemble components
All wastes must be treated, eliminated or recycled according to their classification and to the procedures in
force established by the laws in force in the country where the equipment has been installed.
The symbol indicates that this product shall not be treated as household waste. By making sure that the
product will be properly disposed of, you will facilitate the prevention of potential negative effects for the
environment and human health, which might be otherwise caused by the improper waste treatment of this
product. For more detailed information about the recycling of this product, please contact the product
seller or, as an alternative, the after-sales service or the corresponding waste treatment service.
Chapter 7. Guarantee
7.1. Certificate of guarantee
The guarantee runs for 12 months after the installation date under the conditions set out in the instruction manual. Fill in
the card with all data requested, tear out along the perforations and send in.
7.2. Guarantee conditions
The guarantee runs for 12 months and comes into force on the installation date of the machine. The guarantee covers
free replacement or repair of any parts due to defects arising from faulty material. The repairs or replacement are usually
carried out at the manufacturer's premises, with transport or labour charged to the buyer. If the repair or replacement is
carried out at the buyer's premises, he shall bear the travelling, transfer and labour costs. Work under guarantee can be
carried out exclusively by the manufacturer or by the authorised dealer. In order to be entitled to repairs under the
guarantee, the faulty part must be sent for repair or replacement to the manufacturer or his authorised dealer. The return
of such repaired or replaced part will be considered fulfilment of the guarantee. The guarantee is voided:
1. in case of failure to mail the CERTIFICATE OF GUARANTEE, duly filled in and signed, with in 20 days after the date
of purchase.
2. in case of inappropriate installation, power supply, misuse and mishandling by unauthorised persons.
3. in case of changes made to the machine without prior agreement in writing from the manufacturer.
4. if the machine is no longer the property of the first buyer.
The manufacturer declines all liability for personal injury or damage in case of inappropriate installation or
connection to the power mains or omission of connection to earth or in case of any mishandling of the machine.
The manufacturer undertakes to carry out any variations and changes made necessary by technical and
operating requirements.
IN THE EVENT OF DISPUTES THE COURT OF BERGAMO (ITALY)
(page 83).
SHALL HAVE SOLE JURISDICTION.
L14
Manometer
Cleaning filter
L15
L16
Flow regulator
Flow regulator
L17
L18
Flow regulator
Y1
"A" plier opening coil
"B" plier opening coil
Y2
Y3
"A" plier closing coil
"B" plier closing coil
Y4
Y5
"A" plier carriage return coil
Y6
"B" plier carriage return coil
Central welding device lifting coil
Y7
S
Damper oil tank
23
EN
EN
Publicité
Chapitres
Table des Matières
