Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
FAULT
Motor does not run
Poor cutting performance
Saw works only with difficulty
Chain jumps off sword
Chain becomes hot
SPECIFICATIONS TECHNIQUES
Rated input voltage
Input power
Speed
Safety class
Chain speed
Weight (without guide rail and chain)
Weight (with guide rail and chain)
Oiltank
Chain
Chain bar
Cutting length
Number of chain drive links
Chain width
Teeth of the sprocket chain wheel
Values of noise emissions measured by the
standard:
Acoustic pressure level LpA
93.7 dB(A) K = 2.42 dB(A)
Acoustic power level LwA
105.1dB(A) K = 2.42 dB(A)
estimated guarantee LwA 108 dB(A)
No electricity
Running out of carbon brush
Blunt chain
Chain tension
Check that the chain is
fitted correctly
Chain tension
Chain lubrication
230-240V~, 50 Hz
900 W
29600 min-1
II
15 m/s
3.1kg
5kg
100ml
91PJ040X
10'' (250cm)
10''(190mm)
40
1.3 mm
5
CAUSE
Weighted root mean square acceleration according
to relevant standard
Front handle:6,488 m/s²
Rear
handle:5,981m/s²
The declared vibration total value has
been measured in accordance with a standard
test method and may be used for comparing one
tool with another that the declared vibration total
value may also be used in a preliminary
assessment of exposure.
A warning that the vibration emission
during actual use of the power tool can differ
from the declared total value depending on the
ways in which the tool is used and of the need to
identify safety measures to protect the operator
that are based on an estimation of exposure in
the actual conditions of use (taking account of
all parts of the operating cycle such as the times
when the tool is switched off and when it is
running idle in addition to the trigger time).
REMEDY
Check socket, cable and plug .
Damaged cable: Have repaired by
Customer Service. It is prohibited to
patch the cable with insulating tape.
Damaged switches have to be
replaced by a Customer Service
workshop.
Change the carbon brush, ask a
Customer Service workshop
Sharpen the chain
Chain wrongly fitted
Check the chain tension
Check the chain tension
Check oil level
ATTENTION !
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
must be worn.
K = 1,5 m/s²
K = 1,5 m/s²
Publicité
