Opex Omation 210 Série Manuel D'utilisation page 80

3. Connect the output tray on the right side of the machine
page 45).
4. Turn the cut depth knob to the smallest circle next to the bar for a Standard
Cut (Figure 4-4). It is recommended that the user select this setting first to
cut mail to reduce the chance of cutting the contents.
• If you find incomplete cutting, use the second cut setting.
• The third depth is for envelopes with glued edges or to be used if the
second is not opening the envelope.
• The No Cut position is normally used when only counting the mail.
Note: More accurate counting is achieved with smaller stacks of mail.
40
Omation Series 210™ Envelopener® Operator Manual
No Cut
Figure 4-4: Cutter depth knob
OPEX Corporation
(Figure 4-10 on
Third Cut (deepest)
Second Cut (deeper)
Standard Cut (shallowest)
Operation