emerio FN-123103 Mode D'emploi page 5

FN-123103
PARTS DESCRIPTION
1. Front guard
2. Fan blade
3. Fixation screws for rear guard (x4)
4. Rear guard
5. Base locking screw and washer
6. Grill locking screw and nut
7. Blade fastening screw
8. Motor shaft
9. Motor unit
10. Oscillation knob
11. Speed control switch
12. Connecting screw
13. Standing shaft
14. Standing base
15. Clip
16. Handle
ASSEMBLY INSTRUCTIONS
1. Loosen the base locking screw and washer (5) from the standing shaft (13).
2. Insert the standing shaft with the motor unit (9) into the center hole of the standing base (14). Fix with the
base locking screw and washer (5).
3. Loosen the four fixation screws (3) from the front side of the motor unit. Attach the rear guard (4) onto the
motor unit by aligning the screw holes on the rear guard and the front side of the motor unit. Tighten back
the four fixation screws to fix the rear guard. Make sure the handle (16) on the rear guard is on the top.
4. Loosen the blade fastening screw (7) from the fan blade (2). Attach the fan blade onto the motor shaft (8).
Tighten back the blade fastening screw to fix the fan blade. Make sure it fixes at the flat part of the motor
shaft.
5. Hook the front guard (1) onto the rear guard. Close the guard clips (15) and use the grill locking screw and
nut (6) to secure the two grilles together.
- 4 -
EN