VDO Cyclecomputing MS Notice D'utilisation Abrégée page 28

Pairing the transmitters
– Place the M5 computer in the handlebar bracket
– The speed indicator flashes
– If the heart rate function is activated: heart rate indicator flashes
– If the cadence function is activated: cadence indicator flashes
– Flashing indicator: device searching for the transmitters
– Spin the front wheel: speed is found and displayed
– Press the pedal: cadence is found and displayed
– Put on the heart rate transmitter: heart rate is found and displayed
ATTENTION: If during the pairing process, interferences from other sources
occur, the message "Too many signals" appears on the display.
Press any button to acknowledge this message. After doing so, please move
from the place with the interferences.
Twist the computer to remove it from the handlebar bracket. Place the
computer back into the handlebar bracket. The computer now conducts
a new pairing process.
Possible sources of interference:
– LED light
– Mobile telephone
– GPS receiver
– WLAN
– Theft prevention systems in the shop
These sources of interference can disturb
the pairing process.
54
Pairing the transmitters
ATTENTION: when using the transmitter for the first time, the bike
recognition switch must be set to either BIKE 1 or BIKE 2.
Only then will the automatic bike recognition work.
PRESS and HOLD the button until the LED flashes.
Green LED flashes once = bike 1 is selected
Red LED flashes twice = bike 2 is selected
55