AEG ABB68811LS Notice D'utilisation page 24

24 www.aeg.com
Problem
Audible or visual alarm is on. The cabinet has been re-
The compressor operates
continually.
There is too much frost and
ice.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
Possible cause
cently switched on.
The temperature in the ap-
pliance is too high.
Temperature is set incorrect-
ly.
Many food products to be
frozen were put in at the
same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor-
rectly.
The FROSTMATIC function
is switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrect-
ly.
The FROSTMATIC function
is switched on.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
Solution
Refer to "Door Open
Alarm"or "High Tempera-
ture Alarm".
Refer to "Door Open
Alarm"or "High Tempera-
ture Alarm".
Refer to "Operation" chap-
ter.
Wait a few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FROSTMATIC
function".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" chap-
ter.
Switch off FROSTMATIC
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FROSTMATIC function"
Set a higher/lower tempera-
ture.
Refer to "Closing the door".