Ibiza Light STROBE-75 Manuel D'utilisation page 4

Exterior surface temperature under steady state conditions is 60℃.
Input (IN)-Output (OUT) LINK
The IN and OUT Jack 6.35mm sockets allow the unit to be remotely controlled on its own or together with other
strobes of the same model via an OPTIONAL controller (not supplied with the basic unit).
CAUTION: When installing the device, make sure there is no highly inflammable material within a distance of
min.0.5m!
The following points have to be considered during the inspection:
All screws for installing the devices or parts of the device have to be tightly connected ad must not be corroded.
There must not be any deformations on the housing, glass pane, fixations and installation spots.
The electric power supply cables must not show any damage, material fatigue or sediments. Further instructions
depending on the installation spot and usage have to be adhered to by a skilled installer and any safety problems
have to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or solvents.
CAUTION: Disconnect from mains before starting maintenance operation!
TECHNICAL SPECIFICATIONS
Power supply: .............................................................................. max.220VAC/50Hz
Power consumption: .................................................................................. max.80W
Fuse: ....................................................................................................F1A, 250VAC
Lamps: ........................................................................................... 75W strobe lamp
Maximum ambient temperature Ta: .................................................................. 45°C
Electric products must not be put into household waste. Please bring them to a recycling centre.
Ask your local authorities or your dealer about the way to proceed.
© Copyright LOTRONIC 2011 STROBE75 Page 4