Yamaha FJR1300AP 2010 Mode D'emploi page 41

C
B
1. Front flashing light lead (right)
2. Plastic band (L = 202 mm)
3. Front flashing light sub-lead (right)
4. Wire harness assembly
5. Front flashing light sub-lead (left)
6. Front cowling
7. Front flashing light lead (left)
8. Relay assembly
9. Battery
10. Plastic band (L = 108.5 mm)
11. Protection tube
A. Connect the front flashing light sub-lead,
front flashing light lead and wire harness
assembly.
B. Route the front flashing light lead through
the second air shroud from the top of the
front cowing and connect it with the front
flashing light sub-lead.
C. To front flashing light
RECOMMENDED SPECIFICATIONS
C
B-B
A
B
C-C
D. Clamp the front flashing light lead to the
stay. Set the clamp end downward without
cutting it off.
E. Connect the front flashing light sub-lead,
front flashing light lead and wire harness
assembly. Locate the coupler on the inside
of the vehicle.
F. Clamp the wire harness assembly and front
flashing light lead at the protection tube.
Face the end of the plastic locking tie front-
ward, angled downward. Do not cut off the
excess end of the plastic band.
G. Locate the protection tube in front of the re-
lay assembly.
H. Contain the bare wire inside the protection
tube.
35
A