Start-Up Of The Device/Introduction; Listening To The Fm Radio; Playing Cd - Bigben CD60 Mode D'emploi

Start-up of the device/introduction

• Select a suitable location for the device, such as a dry, flat, non-slip surface on which it is easy to
operate the machine.
• Ensure that the device is sufficiently ventilated.
• Remove the protective film from the display if it is still present.
Power Supply
• Ensure that the voltage is the same as that indicated on the model identification plate.
• Connect the power cable supplied (see battery compartment if necessary) to a properly installed
safety power socket and the mains connector AC on the back of the machine.
Inserting the Batteries (not supplied)
1. Open the lid of the battery compartment.
2. Insert 6 batteries of type UM-2 ("C" size) 1.5 V. Please ensure that the polarity is correct (see the
floor of the battery compartment)!
3. Then close the battery lid.
NOTE:
When a mains cable is connected the batteries are automatically switched off.
CAUTION:
• Batteries can leak and lose battery acid. When not using the system for a long period of time,
remove the batteries.
• Different battery types or new and used batteries must not be used together.
• Do not dispose of batteries with household waste. Return old batteries to the respective collection
facilities or your dealer.
WARNING:
The batteries shall not be exposed to excessive heat such as sunshine, fire or the like. Danger of
explosion!
NOTE:
After about 10 minute without a signal, the device will automatically switch to standby.

Listening to the FM Radio

1. Press the "FUNCTION" button to select the "RADIO" mode.
2. The display will show "F".
3. Adjust radio frequency to your desired station by using the "TUNING" control.
4. Adjust the "VOLUME" control to the desired level.

Playing CD

1. Press the "FUNCTION" button to select the "CD" mode.
2. Open the CD door and place a CD disc with the label up on the CD compartment.
3. Close the CD door.
4. Focus search is performed if disc is inside. Total number of tracks is read and appears on the
display.
5. Press the "PLAY / PAUSE" button to start playing the CD.
6. Adjust the "VOLUME" control to the desired level.
7. Select desired track by using the "SKIP +" or "SKIP -" button.
8. Press the "PLAY / PAUSE" button again when you want to stop playback temporarily.
9. In order to remove a CD, please press the "STOP" button, open the CD compartment and lift the
CD out carefully.
Always keep the CD door closed.
- EN 5 -