Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION METHOD
1. Take the appliance out of the package.
2. There are 1 pc master device and 1 pc remote control in the package. (the base of the
device was non-detachable)
3. Check that the appliance shows no signs of damage before using.
Assembling
Assemble 2 pc semi-circular bases to be a base stand, and then mount the base stand on
the bottom of the unit by tightening 2 pc screws. (Fig.2)
Step 1
Step 2
Picture 2
CONTROL PANEL
Picture 3
Step 3
Step 4
Function of buttons introduction
When the unit connects the power supply first, all the indicators are off.
Press the power switch to position "I", the buzzer beeps twice and the power indicator
lamp
lights up, all other functions and display are closed. Now the system enters the
standby state, the unit can be operated by pressing the button on the control panel.
Under standby State. All the pressing are invalid except
starts working. Press it again, the device turn off.
Mode setting
Press the key to select your preferred output power setting of Low (1000W)
High (2000W)
, and cooling function
each press.The corresponding indicator on control panel (Fig.3) will light up according to
your setting.
Swing
Press the key on the control panel; the unit will begin to oscillate left to right automati-
cally, and the corresponding indicator on control panel (Fig.3) will light up. Then stop
swinging by pressing the key second time.
Temperature setting
Press the key to select your preferred temperature setting of
The corresponding indicator will light up for the selected temperature setting. Once the
room temperature reaches the set temperature, the heater will turn off with fan blowing
out air for 30s and remains in standby mode. Once the room temperature drops 1°C below
the set temperature, the heater will continue to operate in the previous mode.
Continuous heating (CO mode)
Under this mode, the default temperature of continuous heating is 35°C. Under this mode,
the heater will continue to operate on Low Heat mode or High Heat mode depending on
the mode setting.
When the ambient temperature is over the setting temperature, the heater will stop and
oscillation key
will be invalid, and start cooling function with Led_
ambient temperature going down below the setting temperature, heating function is
unable to use with Led_heating
and
Timer
Press the key to select your preferred timer hour from 1h-2h-4h-8h-cancel for automatic
shut off by each press.
The corresponding indicator on control panel (Fig 3) will light up according to your
selected timer setting. But if you set 4h as a timer, then when the timer countdown
60 | 61
key. Press
key, the device
,
to meet the different usage requirements by
or 22°C or 26°C or 30°C,.
on. Before the
off. Oscillation is able to use under cooling mode.
GB
Publicité
