Télécharger Imprimer la page

Jumbo ayce DF-HT5810P Manuel D'utilisation page 30

Publicité

Les langues disponibles

Les langues disponibles

Keep the appliance and cable away from sources of heat, sharp
objects or anything that may cause damage.
Ensure the appliance is switched off before connecting to the mains
power supply.
To disconnect the appliance, switch it "OFF", and then remove the
plug from outlet. Do not pull the cord to disconnect the plug.
Switch off the power supply and disconnect from mains supply
when not in use, before cleaning or other maintenance.
Do not operate in areas where gasoline, paint or other flammable
liquids are used or stored.
Indoor use only.
To prevent a possible fire, do not block air intakes or exhaust in any manner.
Don't touch the hot surfaces.
Do not use pesticide or other flammable spray around the product
because it will damage the device and cause fire.
Do not insert or allow foreign objects to enter any ventilation or
exhaust opening, as this may cause an electric shock, fire or
damage to the appliance.
Always ensure that hands are dry before operating or adjusting any
switch on the product or touching the plug and socket-outlet.
Do not leave this appliance unattended when it's in use.
The most common cause of overheating is deposits of dust or fluff
in the appliance. Ensure these deposits are removed regularly by
disconnect the appliance and vacuum cleaning air vents and grilles.
Do not place the heater on carpet, don't place the cable under
carpets. Arrange cord away from traffic areas so that it will not be
tripped over.
TECHNICAL SPECIFICATIONS
Model
Power
Rated Voltage
Protective Class
Remote Control
DF-HT5810P
2000W
220-240V~ 50Hz
Class II
Yes
PRODUCT DESCRIPTION
Picture 1
1
Indicating panel
3
Air outlet grille
5
Power cord & plug
7
Air inlet grille
OPERATION
Note!
Since the appliance and its heating elements are slightly greased when delivered,
there might be a slight development of smoke and odour the first time it is used.
This is harmless and stops after a short a while. Be sure to provide for sufficient
ventilation during such time.
Warning! Ensure that there is sufficient distance from the wall, fixtures or other appli-
ances. The distance must be at least 1 m to exclude the risk of fire.
58 | 59
2
Remote control receiver
4
Base
6
Handle
8
Power switch
GB

Publicité

loading