Geemarc AMPLICALL16 Mode D'emploi page 6

INSTALLATION
Volume Control Slide Switch
The volume control slide switch can be used to set the
volume of the alarm sound and switch the unit on/off.
The Pairing Procedure:
The supplied door bell has been paired with the base,
there is no need to pair them. If the door bell is not paired
with the base or you wish to pair the base with another
door bell, please follow the pairing procedure below:
Press and hold the Pairing/Test button of the unit whilst
pressing the doorbell button until the strobe flasher LED
starts to flash. The unit will make a beep sound to confirm
that pairing has taken place successfully.
Please note that the pairing procedure overwrites the last
doorbell that was paired to the unit.
To check whether the device is working properly and has
been paired correctly, press the pairing/testing button
once. The device should sound the alarm and flash.
Operation
Once the Amplicall 16 and the door bell have been
placed in the required locations and all required batteries
have been inserted, you are ready to use the device.
To use the device, the person who needs assistance
must press the door bell button of the door bell.
5