Dometic CAM45 Mode D'emploi page 15

CAM45
7.2 Fitting the camera
!
CAUTION!
Select a location for the camera and attach it firmly enough so that it cannot under any
circumstances fall off and injure bystanders (e.g. by being knocked off by branches
brushing over the roof of the vehicle).
I
NOTE
If installing the camera alters the vehicle height or the length specified in the vehicle
documents, your vehicle must be inspected by the appropriate authorities.
This authority must note any such changes your vehicle documents.
Observe the following installation instructions:
•
To provide a suitable viewing angle, the camera must be attached at a height of at least 2 m.
Ensure that you have a firm place from which to work when mounting the camera.
•
Make sure that the installation location of the camera is sufficiently firm (e.g. to prevent the
camera from being knocked down by branches that may brush the roof of the vehicle).
Mount the camera bracket horizontally and in the middle of the rear of the vehicle (fig. 0,
•
page 6).
•
The most secure type of attachment is with screws fitted through the body (not included in
scope of delivery). Please observe the following instructions:
– There must be sufficient space behind the chosen installation location to be able to carry
out the mounting procedure.
– Suitable measures must be taken to prevent water penetrating through any holes made
(e.g. by using screws and sealant and/or spraying the outer attachment parts with sealant).
– The location on the body where you wish to attach the camera must be rigid enough to
allow the camera to be tightly fastened.
•
Check beforehand that there is sufficient space on the other side for the drill head to come out
(fig. 2, page 4).
•
If you are not sure about the location you have chosen, ask your vehicle manufacturer or dealer.
I
NOTE
We recommend greasing the threads of the bolts to prevent corrosion.
To perform the installation, proceed as follows:
➤ Hold the camera at the chosen location and mark at least two different points for the drill holes
and the duct for the connection cable (fig. a, page 6).
➤ Using a hammer and centre punch, gently pre-punch the previously marked points to prevent
the drill head from slipping off.
EN
Fitting the camera
15