Publicité
Les langues disponibles
Les langues disponibles
S 2030 /
XXX
Warning: Please read this instruction manual carefully before using the instrument and keep it for future use.
A. SAFETY INSTRUCTIONS
1. The device is intended exclusively for private and not for commercial use. Only use this device as describe in this
instruction manual.
2. Never try to repair it by yourself. It must be repaired by the manufacturer or its service agent or a similarly
qualified person in order to avoid an electric shock.
3. Keep it away from heat sources such as radiators, to avoid deformation of plastic parts.
4.
Do not use coarse or abrasive sponges/cloths or steel wool to clean the appliance.
5. This unit is not designed to be operated by means of an external timer or a separate remote control system.
B. HOW TO USE IT
1) Insert or replace batteries
- Remove the battery cover on the back of the unit.
- Insert 4 AA batteries observing the correct polarity indicated.
- Replace the cover.
2) Installation
Determine the exact location where you want to install the light fixture.
*Two different installation options are provided, it is recommended to use the standard installation
wherever possible
STANDARD INSTALLATION
1. Prepare area where you what to mount the light unit, clearing any loose debris, and ensuring
that you have adequate space to mount the light before drilling any holes. There needs to be a
small space left above the unit so that it can be hooked over the screws.
2. Mark where you want the two screws to be mounted, they should be 57mm apart and horizontal.
3. Drill pilot holes using a 1.5mm drill bit to a depth of 19mm.
4. If you hit a wall stud, or are fixing to a wooden surface, use only the supplied screws to install the
light fixture. If the wall is hollow, or you are drilling in to masonry, using the pilot holes as guide,
drill again using a 6.5mm drill bit and insert a wall anchor into each hole. Tap each wall anchor
lightly with a hammer, until they are flushed with the wall surface.
5. Thread a screw into each hole (or wall anchor if used) leaving 3.5mm of the screw un-threaded,
to secure the light fixture.
6. Match the holes on the base of the light fixture (narrow end of holes facing upwards) with the
screw heads and slide downward to secure the light fixture.
DOUBLE SIDED ADHEVISE STRIP INSTALLATION (INCLUDED)
1. Choose a smooth surface for best adhesion and wipe clean.
2. Peel one side of the adhesive strip and apply to the base of the light. For best results, place the
adhesive strip in a triangle shape around the base.
COB DUO PIVOT LIGHT
EN
Publicité
