EWT Clima 901TLS Mode D'emploi page 3

UK
R
Clima 901TLS
Specification
2.0kW Thermostat & Heat Switch with Cool Blow
IMPORTANT : THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Important Safety Advice
DO NOT use the heater on deep pile carpets or the long hair type of rugs,
or less than 750mm (30") away from any overhanging surface. Keep
combustible materials such as drapes and other furnishings clear from
the front, sides and rear of the heater. Do not use the heater to dry your
laundry.
DO NOT use the heater in the immediate surroundings of a bath, a shower
or a swimming pool.
DO NOT place the heater directly below a fixed socket outlet.
The socket-outlet must be accessible at all times to enable the mains plug
to be disconnected as quickly as possible.
DO NOT COVER or obstruct the air inlet and outlet openings in any way.
The heater must be on a flat stable surface when in use.
WARNING: This appliance must only be operated in the upright position
as indicated in Fig. 1.
DO NOT operate the heater with the mains lead overhanging the front
outlet grille.
NEVER leave the heater unattended when it is used by or near the aged,
infirm person's or children.
THE HEATER CARRIES THE WARNING SYMBOL INDICATING THAT
IT MUST NOT BE COVERED.
The instruction leaflet belongs to the appliance and must be kept in a safe
place. If changing owners, the leaflet must be surrendered to the new
owner.
IMPORTANT – If the mains lead of this appliance is damaged, it must be
replaced by the manufacturer or its service agent or a similarly qualified
person in order to avoid a hazard.
WARNING: In order to avoid a hazard due to inadvertent resetting of the
thermal cut-out, this appliance must not be supplied through an external
switching device, such as a timer, or connected to a circuit that is regularly
switched on and off by the utility.
Electrical connection
This heater must be used on an AC ~ supply only and the voltage marked on the
heater must correspond to the supply voltage.
The appliance should not be operated until all Safety Warnings and operating
instructions have been read.
Using the Heater
Heat Control - see Fig. 2
-
Off
-
Cool Blow*
I I I I I
-
Half heat
II II II II II
-
Full heat
Thermostat Control - see Fig. 3
The heat output is controlled by the thermostat, according to the room temperature.
Turn the thermostat knob fully clockwise to maximum setting initially. When the room
is warm enough, reduce the setting slowly until the heater just clicks off.
The heater will now cycle on and off to maintain your selected room temperature.
An audible click may be heard when the thermostat operates - this is normal.
Note : If the heater does not come on when the thermostat is at a low setting, this
is normally because the room is warmer than the thermostat setting and is not a
fault.
* When the heat control is set to
maximum.
Position will turn the heater on and off to maintain a temperature of approximately
5°C.
1
(IP21)
for Cool Blow, set the thermostat control to
2
228
276
166
Safety - overheat protection
For your safety, this appliance is fitted with a thermal cut-out. In the event that the
product overheats, the cut-out switches the heater off automatically. To bring the heater
back into operation, remove the cause of overheating, then turn off the electrical
supply to the heater for a few minutes.
When the heater has cooled sufficiently reconnect and switch on the heater.
If the cut-out operates repeatedly, contact your supplier.
Cleaning
WARNING ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE
CLEANING THE HEATER.
Do not use detergents, abrasive cleaning powders or polish of any kind on the heater.
Wipe with a dry cloth to remove dust and a damp cloth (not wet) to clean off stains. Be
careful not to allow moisture into the heater.
Ensure that dust or fluff does not accumulate inside the heater as this could lead to
overheating of the element. Use a vacuum cleaner to remove any fluff which does
accumulate.
Recycling
For electrical products sold within the European Community.
At the end of the electrical products useful life it should not be disposed of
with household waste. Please recycle where facilities exist. Check with
your Local Authority or retailer for recycling advice in your country.
After Sales Service
Should you require after sales service or should you need to purchase any spares,
please contact the retailer from whom the appliance was purchased or contact the
service number relevant to your country on the warranty card.
Please do not return a faulty product to us in the first instance as this may result in
loss or damage and delay in providing you with a satisfactory service.
Please retain your receipt as proof of purchase.
3