Operation Instructions - erba 33607 Mode D'emploi

GB - INSTRUCTION MANUAL

8. OPERATION INSTRUCTIONS

Press the spindle lock (1) button to keep the spindle from rotating and attach the padholder (5)
to the machine.
Never engage the spindle lock when the machine is plugged in and running!
You can now attach a suitable polishing or sanding pad to the padholder.
Make sure the pads are attached exactly centered on the padholder for smooth operation.
Eccentricity will cause the machine to vibrate/wobble and may damage the machine and/or your workpiece.
Keep the hook and loop fastener of both the padholder and the pads clean.
Rotation speed
The machine is equipped with a rmp-dial (2) and a display.
First switch the machine on using the on/off switch (3).
Then chose the desired rpm (between 1.000 and 3.000 rpm in increments of 500 rpm) by
pressing the ⊕ and ⊖ button on the rpm dial.
The number on the display multiplied by 100 indicates the chosen speed (e.g. „15" on the dis-
play indicates a speed of 1.500 rpm).
Use fewer rpm for polishing and more rpm for sanding.
Do not use more than 1.500 rpm for polishing!
Do not use sanding or polishing pads that are too big or too small - they must have the same
diameter as the padholder (180mm).
Make sure that the piece you are working on is properly fixed to a workbench.
Usually an angle of about 10-15 degrees wields best results for polishing and sanding.
When polishing, make sure the surface is dry and dust-free.
Be careful not to touch and scratch the surface with the edge of the padholder - most polishing
bonnets have a rim that can be put over the edge of the padholder.
Never apply extra pressure - the weight of the machine itself is sufficient!
Polish/sand small indentations, folds, bumps, etc. by hand rather than using the machine.
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 12
Changes, print, punctuation and other errors reserved!
Instruction manual
33607
Issue: 07/2017