Safety Instructions - erba 33607 Mode D'emploi

GB - INSTRUCTION MANUAL

1. SAFETY INSTRUCTIONS

Read this material before using this product. Failure to do so can result in serious injury. KEEP THIS
MANUAL. When giving this machine to third parties, always include this manual. We do not accept
any liabilities for accidents or damages that result from misuse. Removal/Alteration of any
safety devices or of the machine in general will result in the loss of warranty. The
buyer assumes all risk and liability arising out of his or her repairs/alterations to the
original product or replacement parts thereto, or arising out of his or her installation
of replacement parts thereto.
Always keep your work area well lit, clean and free of obstacles.
Do not use the product in the vicinity of ignition sources.
Keep children away from your work area.
Avoid contact with grounded surfaces (eg. pipes, radiators, etc.) to avoid the risk of electric shock.
Do not use the product in moist or wet areas.
Never carry the product on its electric cord. Do not pull the cord to unplug the product. Check the
cord for any damage on a regular basis.
When using the product outdoors, always use suitable outdoor-extension cords/outlets.
Always use propper personal protection equipment (eye-protection, gloves, etc.).
Make sure the product is turned off when plugging in the cable.
Do not wear loose clothing, jewellery or any other accessory that might get caught in the machine.
If you have long hair, wear a hair-net.
Always disconnect the powercord when doing maintainance work, cleaning or changing the mixer.
Never leave the product unattended when children are present.
Check the product for any sign of damage each time before you use it.
Do not attempt to repair the product when it is damaged! Repair work must only be done by au-
thorized, qualified service technicians.
Do not use excessive pressure when polishing or grinding - the weight of the machine generates
enough pressure. Excessive force may damage the machine and/or the surfaces you are working on.
Only use polishing discs and accessories that are suitable for this machine and the required rpm.
Do not touch the polishing discs when the machine is running.
Always replace worn down polishing and sanding discs for best results and to avoid damage to
the machine.
Any maintenance/repair work must be done by a authorized professionals only.
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 10
Changes, print, punctuation and other errors reserved!
Instruction manual
33607
Issue: 07/2017