How To Use The Reference To Zero; How To Print - Sammic PCS Manuel De L'utilisateur

1.- Place the empty container on the scale.
2.- Press the key. After some seconds the view finder will display:
3.- Remove the container and put the sugar inside it. When you remove the container, a negative
number (weight of the container) appears in the UPPER-LEFT indicator.
4.- Place the container on the scale and put sugar in the container until you have 15 kg. Then enter
the price per kilogram press
To clear this function, just press the
substractive from the scale maximum capacity. For example if you have a container that weights 7
kg, The scale only will be able to weight up to 33 kg of product to complete the maximum capacity.

HOW TO USE THE REFERENCE TO ZERO

This function has two uses:
a) Permanent tare: when you wish to weigh some products over a same container several times,
you should use this function , and to eliminate it, just remove the container from the plate and
press key again. As in the tare function this function is also substractive from the scale
capacity, for example: if you reference to 10 kg, the scale only will be able to weight up to 30
kg.
b) Due to voltage variance or some other factor, it is posibble that without having any weight over
the plate, the view finder shows some weight, or the zero flag is not on, then press the
and the scale will be referenced to zero, turning the zero flag on.

HOW TO PRINT

This function sends through the serial port the weight to be printed.
10
ENGLISH
Max kg
100 g
Mi
WEIGHT
kg
g
e=d=
P-PACK
P-PACK
PRICE €/kg
TOTAL €
Max k
100 g
Mi
WEIGHT
kg
g
e=d=5
ZERO
NET
P-PACK
P-PACK
PRICE €/kg TOTAL €
Max k
100 g
Mi
WEIGHT
kg
g
e=d=5
NET
P-PACK
P-PACK
PRICE €/kg
TOTAL €
.
Max kg
100 g
Mi
WEIGHT
kg
g
e=d=5
NET
P-PACK
PRICE €/kg
TOTAL €
key again. It is important to mention that this function is
key