Hella Jumbo 320 FF Instructions De Montage page 10

B min.
A min.
(mm)
(mm)
1.500
350
10
Page 3: Mounting steps
For upright/pendant mounting,
above/below bumper. Lamps
should neither vibrate nor extend
higher than the bonnet and must
be fitted symmetrically.
When mounting auxiliary lamps
with integrated position light it
is necessary to observe certain
mounting dimensions. If these
statutory mounting regulations
are not observed, or if the use
of an additional pair of position
lamps is not permissible do not
operate the position lights.
Leave the lamp socket in the
C min. D min.
auxiliary lamp to prevent leakage.
(mm) (mm)
400 600
Determine mounting position on
flat surface and mark mounting
points.
Drill pilot hole with 3 mm dia. bit
and then bore out to 11 mm.
Protect drilled metal parts with
rust protection paint.
Preliminarily install mount.
Open housing and install bulb.
Installation must take place in
accordance with ECE R48.
It is however essential that
country-specific laws are
observed.
Do not touch bulbs with bare fin-
gers! Use tissue paper or similar.
Assemble housing.
Screw holder and housing toge-
ther and route cable cleanly.
Screw lamps to vehicle (use two-
point mount if required).
Align lamps and tighten screws.