Ecler DP 300 Manuel Utilisateur page 10

When either the 2-way or 3-way mode are selected a new screen will appear automatically.
SETUP
Stereo Link
or
SETUP
Stereo Link
The Stereo Link menu item allows linking various parameters of an input or output stereo pair and its
operation mode can be reached from within the SETUP. When modifying a certain parameter of a linked
channel, the same parameter of the adjacent channel will be changed automatically.
In 2x3-way mode, following channels will be paired:
OUT 1 with OUT 2
OUT 3 with OUT 4
OUT 5 with OUT 6
In 3x2-way mode (LCR), following channels will be paired:
OUT 1 with OUT 2
OUT 4 with OUT 6
OUT 3
OUT 5
STEP and OFFSET functions
In order to define the stereo link parameters either STEP or OFFSET mode must be selected.
 In STEP mode, processor parameters such as filter type, high-pass filter slope, output polarity,
etc. can be linked between channels. If STEP mode is selected, changing a parameter of one
linked channel will cause the value of the same parameter of the pair channel to change
automatically.
 In OFFSET mode, no selection options are offered. Instead, a list of numeric values for
frequency, gain, delay, etc. are presented. When linking two channels, these parameters may be
compensated. Following table shows the linking options for all parameters.
10
ON
OFF