Publicité
Les langues disponibles
Les langues disponibles
Operating functions that are possible with configurator in position SPE
Possible function
Locks the state of the devices to which the command is addressed
Unlocks the state of the devices to which the command is addressed
Unlocks the key connected in N1
and locks the key connected in N2
ON (key in N1) - OFF (key in N2)
with no setting
Cyclical ON/OFF functioning with no setting
(only NO contact)
ON with flash
1)
Selection of fixed adjustment level from 10 to 90% of the dimmer
Repeating of key 1 to 4 of the scenario unit
whose address is specified in A and PL
Scenario module management item F420
Timed ON (2 seconds)
Timed ON (10 minuts)
1) Device to be used with an OFF command for switching off. The flashing
time is specified in the table:
Configurator M
Time (seconds)
None
0,5
1
1
2
1,5
3
2
4
2,5
5
3
6
3,5
7
4
8
4,5
9
5
2) Device to be used with a dimmer actuator and an OFF command for
switching off. The configurator determines the adjustment in % of the
load power.
Configurator M
% on the load
1
10
2
20
3
30
4
40
5
50
6
60
7
70
8
80
9
90
SPE=7 Mode
This mode allows you to execute commands in the standard operating
mode with SPE = 0 (no configurator) when pushbuttons or NC (normally
closed) switches are connected to the interface terminals.
2)
3)
4)
T T
SPE position
Configurator
in SPE position
single function
1
1
1
2
1
—
1
—
1
7
2
aucun÷9
3
1÷9
4
1÷4
6
1÷8
8
1
2
3) Configuration example:
It is recommended to repeat key 3 of the scenario unit item L/N/NT4681
with a traditional pushbutton connected to N1; SPE=4 and M=3 must
be configured.
In positions A and PL1, it is necessary to configure the address of the
scenario unit you want to control with the traditional pushbutton (for
example A=1 and PL1=1 for the unit with address A=1 and PL=1).
If you also configure PL2 (for example with configurator 2), the interfa-
ce is enabled to repeat – using a traditional pushbutton connected to
N2 - key 3 of a second scenario unit with address A=1 and PL=2.
Instead, if positions PL1 and PL2 have the same configurator, both pu-
shbuttons connected to the interface will repeat key 3 of the scenario
unit.
Conversely, it is not possible to execute the command of two different
keys of the same unit with an interface.
4) M=1-8: group of scenarios to be controlled with 2 contacts:
M
First contact (PL1)
1
1
2
3
3
5
4
7
5
9
6
11
7
13
8
15
Configurator value in M
double function
—
—
3
0/I
—
—
—
—
Second contact (PL2)
2
4
6
8
10
12
14
16
Publicité
