Replacing The Oven Injectors; Accessibility And Disassembly Of The Parts; Oven Gas Valve; Oven Igniter Plug - OFFCAR Stile 80FCG10LL Notice D'installation Et D'emploi

5.2 Replacing the oven injector
Remove the base of the oven.
5.2.1 Pilot flame (Fig. 6)
If the pilot flame has been regulated correctly it should envelop the
thermocouple and have a perfect exterior appearance. If this is not the
case, unscrew the screw "G" and check that the injectors installed are the
right ones (see tables 2).
Regulation of the primary air is not necessary for the pilot flame.
5.2.2 Main burner (Fig. 7)
Unscrew the injector "I" and mount the one foreseen with a 12 mm spanner.
6. ACCESSIBILITY AND DISASSEMBLY OF THE PARTS (only for qualified installers)

6.1 Oven gas valve


Unscrew the two attachment screws and remove the front right-hand panel, disengaging the attachment pins.

Unscrew the nuts of the gas pipes and that of the thermocouple, remove the temperature sensor from its position
inside the oven chamber and disconnect the wire of the stack device.

Using a spanner, unscrew the two screws which attach the gas valve.

Mount the new valve.
6.2 Gas cock of the fry-top

Disengage the 4 pins which attach the control panel and remove it.

Unscrew the nuts of the gas pipes and that of the thermocouple and those which attach the gas cock to the gas ramp.

Mount the new gas cock.

6.3 Oven igniter plug


Remove the base of the oven.

Unscrew the attachment nuts of the igniter plug.

Remove the plug.

Disconnect the igniter plug wire.

Mount the new plug.
- 17 -
Fig. 6
Fig. 7