GE Appliances UCG1650LII Instructions De Montage page 7

6 ATTACH THE COMPACTOR TO
THE COUNTERTOP
screws to fasten each retaining bracket at the
top of the compactor to the underside of the
countertop.
• If the brackets cannot be attached to the
underside of the countertop, attach mounting
clips to the bracket. Fasten the compactor to
the cabinet front with mounting screws through
the mounting clips.
Mounting clip
7 REINSTALL THE COMPACTOR
DRAWER
• Grasp the sides of the drawer. Carefully slide
the drawer into the compactor.
Installation
Retaining
bracket
Mounting
screws
Retaining
bracket
Mounting
screw
7
8 INSTALLATION OF THE TRASH
BAG CADDY
• Set the bag caddy into the drawer and hook the
prepunched holes in the caddy on the bag
retainer buttons.
• Set the trash bag into the bag caddy and fold
over.
• Hook the holes in the bag over the bag retainer
buttons.
Trash
bag
caddy
9 FINALIZE THE INSTALLATION
• Turn power on at the source.
• Turn the knob to ON.
• Make sure the drawer is fully closed.
• Lift the foot pedal to start the cycle.
• The ram will travel downward, reverse and
return to the starting position.
• The compactor will shut off automatically.
• The cycle should take less than 30 seconds.
• Refer to your Owner's Manual for operating
instructions.
(on some models)
Bag retainer
buttons