Publicité
Les langues disponibles
Les langues disponibles
1 UNPACKING THE COMPACTOR
• Move the compactor close to the installation
location.
• Use a section of the shipping carton to protect
the finished floor.
• Remove all protective packaging materials such
as tape or shipping pads. Remove waxy residue
caused by shipping material with a mild solution
of liquid household cleaner and water.
• Check that the power supply cord is attached
to the cord clip on the rear of the compactor.
Cord clip
IMPORTANT: Use the shipping carton as a pad.
Do not slide the compactor across a finished
floor. Damage will occur.
• Open the compactor drawer and remove any
shipping materials or other items shipped in the
drawer.
• Do not remove the compactor bag (if installed).
• Grasp the sides of the drawer and lift it out of
the compactor. Place the drawer on a protected
surface. The drawer can scratch a finished floor.
Installation Preparation
2 LEVELING THE COMPACTOR
• The top of the compactor should be at least
You can adjust the height of the compactor by
turning the screws on the front leveling legs and
rear wheels.
• Place a level inside the compactor on the floor
of the cabinet.
• Use the leveling legs to adjust level front to back
and side to side.
5
Front leveling legs
Rear wheels
Publicité
