AIRFORCE F75 Luce Prescriptions De Montage Et Mode D'emploi page 20

OPERATION GB
Luce
From off position the stand-by control mode can be activated by pressing any button. The symbol will
then light up softly giving the user the possibility to see and choose the function.
By pressing one more time any button will activate the corrisponding function and the symbol will then
light up completely. To ensure a low level of energy consumption,this control has a special device which
lets the symbols remain lighted up half way, in a stand mode, for about 1minute. The symbols will switch
off afterwards.
A. ON/OFF button- atmosphere light: by pressing this button 2-4 lights situated at the back of the hood
and on the sides will switch on giving a decorative effect with a soft light.;
B. ON/OFF button- hood's light : by pressing this button 2 lights will switch on lighting the hob;
C. ON/OFF button- 4 speed motor: by pressing this button the hood will start to operate at the same
speed as before being switched off. By using D and E it is possible to change the extracting speed
(capacity);
D.Decreasing extracting speed (capacity) button: by pressing this button the extracting speed (capacity)
will decrease;
E.Increasing extracting speed (capacity) button: by pressing this button the extracting speed (capacity)
will increase;
F. ON/OF TIMER: by pressing this button the selected extracting speed (capacity) will last for 5 minutes;
Selected extracting speed (capacity) indicator and filter saturation;
Grease filters saturation : after every 40 hours of use of the hood , the speed indicator will flash slowly
indicating that the metal filters need to be washed.
Charcoal filters saturation : after every 120 hours of use of the hood , the speed indicator will flash fast
indicating that the charcoal filters need to be replaced.
Note: by pressing at the same time the buttons D and E will reset the filters saturation indicator. Attention!
This function should only be used after performing the maintenance of the filters.
All hoods with capacities exceeding 650 m3/h have the last timed speed; It lasts for 7 minutes, after
which it automatically returns to the last non-timed speed.
20