Sangean PR-D8 Mode D'emploi page 9

Operating the Radio
This radio is equipped with three tuning methods- scanning tuning,
manual tuning and preset recall.
Scan Tuning
1. Press the power button to turn the radio on.
2. Select the required waveband by pressing the band button
For FM band fully extend and rotate telescopic aerial antenna to
get the best reception. For AM (MW) band, rotate the radio to
get best signal.
3. Press and release Scan button
more than 2 seconds will activate time setting), the radio will
search up and will stop automatically when it finds a radio
station with good signal. Press the scan button again to pick up
the found station.
The radio will continue to search for the next available stations,
if you do not press scan button again when it finds a
radio station.
4. Rotate the Volume Control to get required sound level.
5. To turn the radio off, press the power button. The display will
show OFF.
(press and hold Scan button
GB
8