Before Starting Up; Engine Oil; Controlling The Oil Level - Zipper ZI-STE3000L Mode D'emploi

7 Engine switch
8 Transport handle
9 Shore
10 Fuel valve
11 Starting handle
12 Air filter
13 Wind-block door
14 Machine frame
15 Sparking plug
16 Wheels
17 Fuel tank cap
16

BEFORE STARTING UP

The oil must:
Be suitable for 4-stroke en-
gines
HD Quality
Classification SG, SF/CC or CD
16.1.1

Controlling the oil level

Stop the generator.
Place it on a flat ground.
Wait for 5 minutes.
Pull out the dipstick, clean it and do it into the oil again to read it.
When there's too less oil in it you must refill some.
You must refill the oil till the lower edge of the filling port for oil.
Fasten the dipstick and the cap of the filling port again.
Z.I.P.P.E.R Maschinen Austria www.Zipper-maschinen.at
For stopping the machine
For short transports
For placing the machine
Turn off after operation
Always let it roll up after pulling
Always keep it clean!
For protecting the main parts
Control it regularly
Take care of the pressure
Fasten it well
16.1
Stromerzeuger / Generator ZI-STE3000L
BEFORE STARTING UP
E
n
g
i
n
e
o
i
l
Seite 33