Technical Description; Mounting The Magicsafe Msg150 - Dometic Waeco MagicSafe MSG150 Instructions De Montage Et De Service

Technical description

6 Technical description
The MSG150 gas detector can be used as a warning device in many areas to detect
gases with a narcotic effect before they can take effect.
The gas detector contains a sensor and an acoustic signal generator and is connected to
a 12/24 Vg voltage supply, e.g. the cigarette lighter in a vehicle.
In addition to this, the gas detector contains an internal relay. An external siren of signal
lamp can be connected to this.
The connection terminal for the relay connection can be found on the back of the gas
detector (fig. 3, page 4).
No. in
fig. 3, Description
page 4
1 Relay contact 1
2 Relay contact 2
You can operate the gas detector in three ways:
 As single device
 In combination with the external siren (item no. 9101600008)
 In combination with the MagicSafe alarm system MS660 or DVS90
7

Mounting the MagicSafe MSG150

7.1 Tools required
For mounting you will require the following tools:
 Measuring ruler (fig. 1 1, page 3)
 Centre punch (fig. 1 2, page 3)
 Hammer (fig. 1 3, page 3)
 Drill bit set (fig. 1 4, page 3)
 Electric drill (fig. 1 5, page 3)
 Screwdriver (fig. 1 6, page 3)
24
MagicSafe MSG150
EN