Procedure : "Dead Man" Function Time Programming - Jay Electronique UD Série Notice Technique D'installation Et D'utilisation

3.5.3 Procedure : "Dead man" function time programming

(Automatic shutdown of transmitter UDE)
1- Switch off the UDR receiver.
2- Insert the electronic key in the UDE transmitter unit.
3- Holding buttons n°1 and n°3 * pressed, unlock the stop palmswitch button on the transmitter
(fig.1).
The "dead man" time is displayed by two flashing indicator lights on the transmitter representing
the tens (red) and the units (green) of the number of minutes.
If transmitter red and green indictor lights flash in alternation :
The electronic key is locked. Press the stop palmswitch button and follow procedure described
on chapter §3.5.1. Start again this procedure at point Nb.3.
4- Select the new time using buttons n°1 and n°2 (fig.2&3).
Press button n°1 to increment the tens and button n°2 to increment the units.
During these operations, the new time selected is displayed by the two indicator lights on the
transmitter.
5- Once you have selected the desired "dead man" time (between 01 and 99), press the «On/
Horn» button to validate your selection (fig.4).
Caution: No. 99 corresponds to an infinite "dead man" time
> This function is then deactivated and forgetting to switch off the transmitter (by
pressing the stop palmswitch button) will result in complete discharge of the
battery pack.
6- Exit the "dead man" time programming mode by pressing the stop palmswitch button (fig.6).
Fig.1
* = If the button n°3 is not BPSV or BPDV type, use then the green «On/Horn» button.
UD - 319472K
Fig.2
DATA
Fig.5
Fig.4
électronique
+10
mn
électronique
+1
mn
Fig.3
Fig.6
DE EN FR
- 83 -