Philips NT5175 Mode D'emploi page 12

ENGLISH
12
1 Make sure the appliance is switched off.
2 Rinse the cutting element of the nose/ear trimming head with hot
water.
3 Switch on the appliance and rinse the cutting element once more to
remove any remaining hairs. Then switch off the appliance again.
Tip: The best way to clean the cutting element is to immerse it in a bowl with
warm water for a few minutes and then switch on the appliance.
Note: You can also use the cleaning brush to clean the nose/ear trimming head.
4 Rinse the eyebrow combs with lukewarm water.
Note: You can also use the cleaning brush to clean the eyebrow combs.
5 Rinse the precision trimming head and the precision trimming comb
with lukewarm water.