Hama 00136697 Mode D'emploi page 9

6.2 Setting angle and tilt
The viewing angle and tilt of the holder can be continuously adjusted using a ball head.
• Always set the angle and tilt without the terminal device inserted.
• Loosen the clamping screw of the ball head.
• Set the angle and tilt as desired and tighten the clamping screw.
6.3 Inserting/removing the Dashcam
Note
Continually check that the suction cup holder is securely seated and the Dashcam is securely held.
• Slide the Dashcam into the holder (14) of the suction cup holder.
• Pull the Dashcam out of the holder by carefully moving the Dashcam to and fro.
7. Operation
7.1. Connection to the vehicle's electrical system
Warning – rechargeable battery
• Only use suitable charging devices with USB connections for charging.
• As a rule, do not use charging devices or USB connections that are defective and do not try to
repair them yourself.
• Do not overcharge the product or allow the battery to completely discharge.
• Avoid storing, charging or using batteries in extreme temperatures.
• When stored over a long period of time, batteries should be charged regularly (at least every
three months).
• Connect the included Mini-USB charging cable to the Mini-USB charging socket (11) on the
Dashcam and to the vehicle socket of the electrical system.
• The Dashcam automatically switches on when the engine is started.
• The status LED (12) is constantly lit red.
Note - Battery capacity
The battery has a limited life of about 2–3 minutes. This buffer function is used for continuation of
the time, for example. Longer operation is possible only with a connected vehicle adapter.
7