Publicité
Les langues disponibles
Les langues disponibles
VI. OPERATION
1. Push the switch lock lever down, pull
the power switch.
•
The switch lock can be disengaged by
pushing in the off-lock switch from ei-
ther side.
•
The speed increases with the amount
of depression of the power switch.
2. Once cutting is finished, release the
power switch.
3. Check that the temperature of the
blade has dropped suffi ciently, and then
remove the blade.
When operating the tool by pulling the
trigger, there may be a momentary lag
before rotation starts. This does not
signal a malfunction.
•
This lag occurs as the tool's circuit-
ry starts up when the trigger is pulled
for the first time after installing a new
battery pack or after the tool has not
been used for at least 1 minute. Ro-
tation will start without any lag during
second and subsequent operations.
Switch lock
A switch lock prevents the motor from
starting if the switch is pulled inadvert-
ently. Normally, the lock is engaged.
•
To disengage the lock, press the
off-lock switch. (The switch can be
pressed on either side of the tool.)
•
While you are on the switch, the tool
will continue to operate even if you re-
move your fingers from the off-lock
switch.
Fine-tuning the tool speed
with the switch
The tool speed varies continuously de-
pending on how far the switch is pulled
back. When starting to make a cut, pull
back on the switch lightly to start cutting
gradually. When the switch is released,
the brake will engage so that the tool
stops immediately.
Cutting
NOTE:
•
Hold the protective shoe against the
material being cut, taking care to
align the reciprocating saw blade
with the desired cut position, and
pull the switch.
•
The blade may vibrate occasionally,
which is a normal phenomenon.
•
If cuttings accumulate on the une-
ven surfaces near where the recipro-
cating saw blade is attached, clean
them off before resuming work.
•
Once the tool has started, it will con-
tinue to operate even if you remove
your fingers from the off-lock switch.
•
Check that there are no obstacles to
cut underneath workpiece.
•
Check that there are no objects such
as nails in the material to be cut.
If the blade comes into contact with
any such objects during cutting, a
strong reaction force will be generat-
ed and severe injury may occur.
•
Do not place your hand on the ob-
ject in the direction cutting is to take
place. If this is not observed, there is
a risk of injury.
•
Do not touch the jigsaw blade imme-
diately after cutting. If this is not ob-
served, burns may occur.
-12-
Publicité
