Trevi XT 104 BT Mode D'emploi Et Branchement page 12

ENGLISH
BLUETOOTH
1. Turn on the unit and press the MODE button (9) on the unit repeatedly, or press the MODE button (25) on the
remote control and select the BLUETOOTH function;
2. The writing "bt" on the display will start to flash and the system will automatically search for external Bluetooth
devices to be paired
3. Activate the Bluetooth functionality on the external device to be paired and start searching for the devices. At the
end select the "XT 104 BT" device;
4. Enter the "0000" password if required;
5. Once paired, a short confirmation tone will sound and the "bt" symbol will remain fixed;
6. Press (2) button on unit, or the

stop playback temporarily;
7. Press (3) or
9 :
listening to move to the previous or next track.
AUX-IN INPUT
- Use a 3.5mm Stereo jack cable or an RCA cable to connect the AUX-IN inputs (15 and 16), located behind the
unit, to the audio output of the TV, DVD or another device/source;
1. Press the "Power" button to turn the speaker on;
2. Press the "MODE" button to switch to AUX-In mode:
3. Use the controls on the connected device to begin playing music.
TROUBLESHOOTING
If the Soundbar does not work properly, check this short list before taking it to a TREVI authorised service centre.
In any case, do not try to repair the device, this will void the warranty. Only TREVI authorised service centres are
authorised to perform operations on this product.
No Sound:
Check if MUTE function on AUX mode, or PAUSE function on USB or Bluetooth mode, are enabled.

Check that the correct input has been selected.

(32) button on the remote control to start playback; press it again to

(8) button on the unit, or /CH- (18) or /CH+ (30) button on the remote control, while
9 :
12
XT 104 BT